automating commands on nodes

Salim Mounir AlAoui salim at
Mon Jun 5 13:01:32 PDT 2000

for remote commands you can go to: then you go to /pub/sadm/rpms
there you will find cfm rpm which after installed will permit you to use
"scmd" command. You type scmd "<command>" <host list>, it will run
whatever command you want on any node of the beowulf. cfm is also very
usefull to manage and keep track of your beowulf modifications.

Salim Mounir Alaoui					salim at
Computer Science  Dept.					salaoui at
Research Assistant.					salim at
Florida Institute of Technology
Melbourne, Florida
Voice: (407) 537-8025.

More information about the Beowulf mailing list