[vortex] [Fwd: 3com card in a gateway machine...]

Andrew Morton andrewm@uow.edu.au
Fri, 14 Jul 2000 04:14:59 +0000


This is a multi-part message in MIME format.
--------------132CA0FC1E80C3F712669DCC
Content-Type: text/plain; charset=us-ascii
Content-Transfer-Encoding: 7bit

Another Cardbus device has been spotted...

-------- Original Message --------
Subject: 3com card in a gateway machine...
Date: Wed, 12 Jul 2000 14:37:28 +0930 (GMT+9:30)
From: Benjamin Close <clobs001@lux.levels.unisa.edu.au>
To: linux-kernel@vger.rutgers.edu

Hello,
	My gateway laptop has a 3com device (don't know what type)
however, I can't get it detected with linux. I've tried all the modules
which exist but to no avail. It is built onto the motherboard and is
100/10MB. My laptop is a gateway 2150. The device is also in the
gateway 9300. Attached is a dump of lspci -vvvv 

Cheers,
	Benjamin
--------------132CA0FC1E80C3F712669DCC
Content-Type: text/plain; charset=us-ascii;
 name="output"
Content-Transfer-Encoding: 7bit
Content-Disposition: inline;
 filename="output"

00:00.0 Host bridge: Intel Corporation 440BX/ZX - 82443BX/ZX Host bridge (rev 03)
	Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B-
	Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort+ >SERR- <PERR+
	Latency: 64 set
	Region 0: Memory at f8000000 (32-bit, prefetchable)
	Capabilities: [a0] AGP version 1.0
		Status: RQ=31 SBA+ 64bit- FW- Rate=x1,x2
		Command: RQ=0 SBA- AGP- 64bit- FW- Rate=<none>

00:01.0 PCI bridge: Intel Corporation 440BX/ZX - 82443BX/ZX AGP bridge (rev 03) (prog-if 00 [Normal decode])
	Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B-
	Status: Cap- 66Mhz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
	Latency: 128 set
	Bus: primary=00, secondary=01, subordinate=01, sec-latency=64
	I/O behind bridge: 00002000-00002fff
	Memory behind bridge: f4100000-f5ffffff
	Prefetchable memory behind bridge: fff00000-000fffff
	BridgeCtl: Parity- SERR- NoISA+ VGA+ MAbort- >Reset- FastB2B+

00:07.0 ISA bridge: Intel Corporation 82371AB PIIX4 ISA (rev 02)
	Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
	Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
	Latency: 0 set

00:07.1 IDE interface: Intel Corporation 82371AB PIIX4 IDE (rev 01) (prog-if 80 [Master])
	Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
	Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
	Latency: 64 set
	Region 4: I/O ports at 1050

00:07.2 USB Controller: Intel Corporation 82371AB PIIX4 USB (rev 01) (prog-if 00 [UHCI])
	Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
	Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
	Interrupt: pin D routed to IRQ 9
	Region 4: I/O ports at 1060

00:07.3 Bridge: Intel Corporation 82371AB PIIX4 ACPI (rev 03)
	Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
	Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-

00:08.0 CardBus bridge: Texas Instruments PCI1225 (rev 01)
	Subsystem: Gateway 2000: Unknown device 2150
	Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
	Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
	Latency: 168 set, cache line size 08
	Interrupt: pin A routed to IRQ 0
	Region 0: Memory at <ignored> (32-bit, non-prefetchable)
	Bus: primary=00, secondary=20, subordinate=22, sec-latency=176
	Memory window 0: 00000000-00000000 (prefetchable)
	Memory window 1: 00000000-00000000 (prefetchable)
	I/O window 0: 00000000-00000003
	I/O window 1: 00000000-00000003
	BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset+ 16bInt+ PostWrite+
	16-bit legacy interface ports at 0001

00:08.1 CardBus bridge: Texas Instruments PCI1225 (rev 01)
	Subsystem: Gateway 2000: Unknown device 2150
	Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
	Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
	Latency: 168 set, cache line size 08
	Interrupt: pin A routed to IRQ 0
	Region 0: Memory at <ignored> (32-bit, non-prefetchable)
	Bus: primary=00, secondary=23, subordinate=25, sec-latency=176
	Memory window 0: 00000000-00000000 (prefetchable)
	Memory window 1: 00000000-00000000 (prefetchable)
	I/O window 0: 00000000-00000003
	I/O window 1: 00000000-00000003
	BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset+ 16bInt+ PostWrite+
	16-bit legacy interface ports at 0001

00:09.0 Multimedia audio controller: Creative Labs: Unknown device 8938
	Subsystem: Gateway 2000: Unknown device 2150
	Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
	Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort- >SERR- <PERR-
	Latency: 12 min, 128 max, 96 set
	Interrupt: pin A routed to IRQ 5
	Region 0: I/O ports at 1800
	Region 1: I/O ports at 1840
	Capabilities: [dc] Power Management version 1
		Flags: PMEClk- AuxPwr+ DSI+ D1+ D2+ PME+
		Status: D0 PME-Enable- DSel=0 DScale=0 PME+

00:0a.0 Ethernet controller: 3Com Corporation: Unknown device 6055 (rev 10)
	Subsystem: 3Com Corporation: Unknown device 6256
	Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B-
	Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
	Interrupt: pin A routed to IRQ 3
	Region 0: I/O ports at 1080
	Region 1: Memory at f4000400 (32-bit, non-prefetchable)
	Region 2: Memory at f4000000 (32-bit, non-prefetchable)
	Capabilities: [50] Power Management version 1
		Flags: PMEClk- AuxPwr+ DSI- D1+ D2+ PME-
		Status: D0 PME-Enable- DSel=0 DScale=1 PME-

00:0a.1 Communication controller: 3Com Corporation: Unknown device 1007 (rev 10)
	Subsystem: 3Com Corporation: Unknown device 6158
	Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B-
	Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
	Interrupt: pin A routed to IRQ 3
	Region 0: I/O ports at 1400
	Region 1: Memory at f4000c00 (32-bit, non-prefetchable)
	Region 2: Memory at f4000800 (32-bit, non-prefetchable)
	Capabilities: [50] Power Management version 1
		Flags: PMEClk- AuxPwr+ DSI- D1- D2+ PME-
		Status: D0 PME-Enable- DSel=0 DScale=1 PME-

01:00.0 VGA compatible controller: ATI Technologies Inc 3D Rage P/M Mobility AGP 2x (rev 64) (prog-if 00 [VGA])
	Subsystem: Gateway 2000: Unknown device 2150
	Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping+ SERR- FastB2B-
	Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
	Latency: 8 min, 66 set, cache line size 08
	Interrupt: pin A routed to IRQ 9
	Region 0: Memory at f5000000 (32-bit, non-prefetchable)
	Region 1: I/O ports at 2000
	Region 2: Memory at f4100000 (32-bit, non-prefetchable)
	Capabilities: [50] AGP version 1.0
		Status: RQ=255 SBA+ 64bit- FW- Rate=x1,x2
		Command: RQ=0 SBA- AGP- 64bit- FW- Rate=<none>
	Capabilities: [5c] Power Management version 1
		Flags: PMEClk- AuxPwr- DSI- D1+ D2+ PME-
		Status: D0 PME-Enable- DSel=0 DScale=0 PME-


--------------132CA0FC1E80C3F712669DCC--