Forcing 100 base-t Full Duplex

Adam Wills (Global 2000) sysadmin@global2000.net
Wed Dec 2 12:01:29 1998


-----BEGIN PGP SIGNED MESSAGE-----

Running Cyclone 3com, driver .99E for the following:

Not using a module, i need to pass the paramater to 'force' full duplex
from lilo.  Reading the ethernet how-to, the lilo how-to, and the
documentation on the vortex www site 

	http://cesdis.gsfc.nasa.gov/linux/drivers/vortex.html which
states:

- --------------------
When loaded as a module the following variables may be set:
 name    type   description
 debug   int    The debug message level, 0 (no messages) to 6 (wordy).
 options int[]  The media type override and card operation settings
..
        16      Full-duplex bit
                16 10baseT full-duplex
                20 100baseTx full-duplex
..
- --------------------

to get the right paramaters to force full duplex (100 baseT as well), i
figured the following would do it:

append="ether=20"

But it doesn't appear to do the trick.  Running the 'vortex-diag' prgram
it reports half-duplex is still set no matter what (and my ether switch
shows errors if i force to full duplex mode at the switch and reboot the
nic card computer, so the card is definately still in half duplex 100 base
T).

Anyone know how to (not using a module) force this thing into full duplex
100 base T?


Vortex-Diag output:

vortex-diag.c:v1.05 5/22/98 Donald Becker (becker@cesdis.gsfc.nasa.gov)
Found a 3Com PCI Ethernet 3c905b rev 0 at 0xec00.
 No interrupt sources are pending.
 Transceiver/media interfaces available:  100baseTx 10baseT.
 MAC settings: half-duplex.

Dmesg reports the following from boot up:

 eth0: 3Com 3c905B Cyclone 100baseTx at 0xec00, 00:10:5a:22:1c:8d, IRQ 11
   8K byte-wide RAM 5:3 Rx:Tx split, autoselect/NWay Autonegotiation 
   interface.
   Enabling bus-master transmits and whole-frame receives.
 3c59x.c:v0.99E 5/12/98 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers
 







Adam Wills					Global 2000 Communications
Director of Networking Systems			1840 Western Ave.
sysadmin@global2000.net  			Albany, NY, 12203
http://www.global2000.net	  		(518) 452-1465



-----BEGIN PGP SIGNATURE-----
Version: 2.6.2

iQCVAwUBNmVyZq7yaLQI4biZAQGEEgP+IMxjzaYupgHOZc7AfF0dDVrw4jVQMVdR
DUywvmGf/ceHkU6ONAotnJQ54kqGZKiBSvEg1VNjX+j+jeKZz3a+JGoxLdiOO3KC
qDBwqGnjhwEFHPO3XLNZR4v9CfIighFOOTvtQbNrjT7+RKjfoN7vQDh+Roi4jw9Q
2znBcJyeC+M=
=phsx
-----END PGP SIGNATURE-----