[tulip] Adaptec ANA-6944A/TX

[Ron Reed]

Is it a problem that the AGP card shows up at IRQ 11 also? Also, the USB
controller shows up at IRQ9. Here is the lspci -v for them:

00:1f.2 USB Controller: Intel Corporation 82820 820 (Camino 2) Chipset USB
(Hub A) (rev 02) (prog-if 00 [UHCI])
        Flags: bus master, medium devsel, latency 0, IRQ 9
        I/O ports at d000 [size=32]

00:1f.3 SMBus: Intel Corporation 82820 820 (Camino 2) Chipset SMBus (rev 02)
        Flags: medium devsel, IRQ 9
        I/O ports at 5000 [size=16]

00:1f.4 USB Controller: Intel Corporation 82820 820 (Camino 2) Chipset USB
(Hub B) (rev 02) (prog-if 00 [UHCI])
        Flags: bus master, medium devsel, latency 0, IRQ 9
        I/O ports at d800 [size=32]
01:00.0 VGA compatible controller: nVidia Corporation Vanta [NV6] (rev 15)
(prog-if 00 [VGA])
        Flags: bus master, 66Mhz, medium devsel, latency 32, IRQ 11
        Memory at d4000000 (32-bit, non-prefetchable) [size=16M]
        Memory at d6000000 (32-bit, prefetchable) [size=32M]
        Expansion ROM at <unassigned> [disabled] [size=64K]
        Capabilities: [60] Power Management version 1
        Capabilities: [44] AGP version 2.0

When I try to insmod pci-scan.o, I get this error:

pci-scan.o: unresolved symbol apm_register_callback
pci-scan.o: unresolved symbol apm_unregister_callback

I have tried the -f on the insmod, but it will not load the module.