[tulip] Netgear FA310TX

[Bryan Burns]

I have a bit of a problem.

I am setting up a Beowulf cluster at my school (Illinois State University) 
and cannot get the Netgear cards to work, here is my setup:

Pentium 200mhz (HP Vectra) with Netgear FA310TX cards and a D-Link DSS-16+ 
switch.  I have tried every mode for the cards and cannot get them to send or 
recieve.  The switch never shows any link beat for any of the cards/modes.

Here is my output from tulip-diag with options set to 13:
--
tulip-diag.c:v2.06 1/8/2001 Donald Becker (becker@scyld.com)
 http://www.scyld.com/diag/index.html
Index #1: Found a Lite-On 82c168 PNIC adapter at 0xfc00.
 Port selection is 10mpbs-serial, half-duplex.
 Transmit started, Receive started, half-duplex.
  The Rx process state is 'Waiting for packets'.
  The Tx process state is 'Waiting for Tx to finish'.
  The transmit threshold is 96.
--

It says 10mpbs even though the '100' light on the card is on.

And here is mii-diag:
-- 
Using the default interface 'eth0'.
Basic registers of MII PHY #1:  3000 7809 0040 6212 0081 0000 0000 0000.
 Basic mode control register 0x3000: Auto-negotiation enabled.
 Basic mode status register 0x7809 ... 7809.
   Link status: not established.
--

Any help would be appreciated.

-- 
Bryan Burns a.k.a "Haplo" <haplo@wwa.com>
A copy of my PGP key is available at:
http://www.wwa.com/~haplo/public_key