accton EN1207D TX

Tom Secula tsecula@cisco.com
Wed Dec 23 12:16:53 1998


how do i get my accton card to be recognized at boot time ? running linux
2.1.128.
when i insmod i get init_module : Device or resource busy. irq 11 is mapped to
pci inta and it's shared by many devices, adaptec 2940, usb port, vga card and
hrd drive contr and the accton ether card.

probably something stupid but i've felt quite dumb lately.....

tulip-diag -a -p 0x2800 gives :

tulip-diag.c:v1.06 9/18/98 Donald Becker (becker@cesdis.gsfc.nasa.gov)
Digital DC21040 Tulip Tulip chip registers at 0x2800:
  69e80000 80004300 00002000 00002000 00fd5800 00fd4800 00fcd000 0000fff0
  70000000 4308e39e 000d1000 0000e10c 1000000f 00000000 00000004 78fa8388
 The Rx process state is 'Unavailable Rx buffer -- Flushing Rx frame'.
 The Tx process state is 'Closing Tx descriptor'.
Transmit stopped, Receive stopped, half-duplex.
 The transmit unit is set to store-and-forward.
 Port selection is 100mbps-SYM/PCS, half-duplex.

lspci gives :

00:00.0 Host bridge: Intel Corporation 440LX - 82443LX PAC Host (rev 03)
00:01.0 PCI bridge: Intel Corporation 440LX - 82443LX PAC AGP (rev 03)
00:04.0 SCSI storage controller: Adaptec AIC-7881U
00:05.0 Ethernet controller: Accton Technology Corporation: Unknown device 1211
(rev 10)
00:14.0 ISA bridge: Intel Corporation 82371AB PIIX4 ISA (rev 01)
00:14.1 IDE interface: Intel Corporation 82371AB PIIX4 IDE (rev 01)
00:14.2 USB Controller: Intel Corporation 82371AB PIIX4 USB (rev 01)
00:14.3 Bridge: Intel Corporation 82371AB PIIX4 ACPI (rev 01)
01:00.0 VGA compatible controller: ATI Technologies Inc 215GB [Mach64 GB] (rev
5c)

Tom Secula SEM
NSP NorthEast
609-478-4579