[Beowulf] Bonding results in 1 HBA for Tx and 1 HBA for Rx.

[Gemmeke Nout]

Hi there Beowulf,
 
Just a quick question.
 
When using bonding on RehHat AS V3.0 I see that eth0 is used for sending
data (Tx) and eth1 for receive of data (Rx). This results in bandwidth of
only 1Gbit/sec.....
 
Fail over works fine however.
 
Any idea if this can be configured ??
 
Thanks,
 
Nout Gemmeke

Consultant

Enterprise Services

 

FUJITSU SERVICES

Fujitsu Services B.V., Het Kwadrant 1

P.O. Box 1067, 3600 BB Maarssen, The Netherlands

Tel: +31 346 598451

Mob: +31 651 218661

Fax:  +31 346 561909            

 

Email: nout.gemmeke at nl.fujitsu.com

Web: nl.fujitsu.com

 

Fujitsu Services B.V., Registered in the Netherlands no 30078286

___________________________________________________________________________

 

The information in this e-mail (and its attachments) is confidential and
intended solely for the 

addressee(s). If this message is not addressed to you, please be aware that
you have no 

authorisation to read this e-mail, to copy it or to forward it to any person
other than the 

addressee(s). Should you have received this e-mail by mistake, please bring
this to the

attention of the sender, after which you are kindly requested to destroy the
original message

and delete any copies held in your system. Fujitsu Services and its
affiliated companies 

cannot be held responsible or liable in any way whatsoever for and/or in
connection with 

any consequences and/or damage resulting from the contents of this e-mail
and its proper

and complete dispatch and receipt. Fujitsu Services does not guarantee that
this e-mail has

not been intercepted and amended, nor that it is virus-free.

 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.scyld.com/pipermail/beowulf/attachments/20041019/6a64df37/attachment.html