Master node install stops during "performing post install configuration"

Chris Richard Adams chrisa at ASPATECH.COM.BR
Tue Mar 27 13:09:27 PST 2001


uhhhh... Not sure if this is the cause, but should I have the slave
nodes already attached to the network.  Just looking in the docs, I see
that during install it will write to the floppy disks of each slave
node. Could this be the cause, because i do not have any slave nodes
attached yet? 

Thanks,
CHris

> -----Original Message-----
> From: Chris Richard Adams 
> Sent: Tuesday, March 27, 2001 5:41 PM
> To: Beowulf (E-mail)
> Subject: Master node install stops during "performing post install
> configuration"
> 
> 
> Hi all;
> 
> During the master node install, once all the files are installed - it
> makes it to the end and says, "performing post install configuration"
> and thats it.  Even thought the install takes less than 15 minutes -
> I've waiting up to 1/2hr - and never makes it past that message.  The
> mouse still moves so I don't think it's frozen.
> 
> I have repeated this error on two different PCs. One compaq (ipaq) the
> other a std. PC with an Intel board. I am doing a custom install, but
> nothing complicated - all beowulf packages with some 
> additional telnet,
> inetd, ftp services.  I'll try to do just a default install 
> and see, but
> any clues?
> 
> I had Redhat 6.2 installed on the machines prior - so I don't think
> there would be any hardware conflicts.
> 
> ???
> Thanks,
> Chris
> 
> _______________________________________________
> Beowulf mailing list, Beowulf at beowulf.org
> To change your subscription (digest mode or unsubscribe) 
> visit http://www.beowulf.org/mailman/listinfo/beowulf
> 




More information about the Beowulf mailing list