Scyld and eth conf

[David Leunen]

> > I just installed the Scyld 2.0 preview release CDrom on the master node.
> > During the installation, I configured the eth0 for the external LAN, and
> > I let the eth1(cluster LAN) untouched. 
> > On the second boot, it says:
> > ...
> > ifup: SIOCADDRT: Network is unreachable
> > ifup: Determining IP information for et1...
> > pumpd:....
> 
> There should more messages before this indicating a failed network driver
> load.


Dec 14 12:28:26 maitre9 kernel: tulip.c:v0.92l 8/19/2000  Written by
Donald           Becker <becker at scyld.com> 
Dec 14 12:28:26 maitre9 kernel:  
http://www.scyld.com/network/tulip.html 
Dec 14 12:28:26 maitre9 kernel: eth1: Digital DS21140 Tulip rev 34
at           0xc481f000, 00:80:C8:46:B4:76, IRQ 10. 
Dec 14 12:28:26 maitre9 kernel: eth1:  EEPROM default media type
Autosense. 
Dec 14 12:28:26 maitre9 kernel: eth1:  Index #0 - Media MII (#11)
described by          a 21140 MII PHY (1) block. 
Dec 14 12:28:26 maitre9 kernel: eth1:  MII transceiver #0 config 1000
status          782d advertising 01e1. 

> What network adapter do you have?

D-link DFE-500TX. 

> Did it work during the install?

During the install, I didn't touch any config of eth1 (configured with
DHCP I think). How can I remove this DHCP for eth1?