[Beowulf] tcp error: Need ideas!
Many of your questions may have already been answered in earlier discussions or in the FAQ. The search results page will indicate current discussions as well as past list serves, articles, and papers.
Gerry Creager gerry.creager at tamu.eduSun Jan 25 07:13:24 PST 2009
- Previous message: [Beowulf] tcp error: Need ideas!
- Next message: [Beowulf] tcp error: Need ideas!
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Joe Landman wrote: > I wonder if the switch could be implicated. We have seen some (cheap) > GbE switches not support (in practice) jumbo frames (irrespective of > literature). Been there, done that. HP claims to be able to handle packets up to 9000 bytes of payload. (9122 total, IIRC) > Nifty Tom Mitchell wrote: >> On Sat, Jan 24, 2009 at 09:36:09AM -0600, Gerry Creager wrote: >>> Couple of follow-up notes. >>> >>> MTU=4500: Had one node fall over with the same overflow errors. >>> MTU=3000: A WRF model is running, but single timesteps are >>> executing 2.5x slower than MTU=1500 > > Segment offload? Is TSO on or off? On. > ethtool -k eth0 > > will tell you. You might also have one very reluctant machine, in the > sense of being unwilling to switch their mtu. Could you do an -bash-3.2# ethtool -K rx off no offload settings changed -bash-3.2# ethtool -k eth1 Offload parameters for eth1: rx-checksumming: on tx-checksumming: on scatter-gather: on tcp segmentation offload: on udp fragmentation offload: off generic segmentation offload: off But here's the one I love: -bash-3.2# ethtool -K tso off no offload settings changed I apparently can't control things with ethtool... > ifconfig eth0 | grep MTU Thought of that. All change appropriately. > on each machine and verify that everyone is using the right MTU? > > >>> >>> I'll go snag the new driver and compile it. After all: What can it >>> hurt! >>> >>> Thanks, Guy! >>> >>> Regards, Gerry >>> >>> Guy Coates wrote: >>>> Hi, >>>> >>>> We have also seen problems with the bnx2 drivers. >>>> >>>> I got a more recent set of bnx2 drivers from Broadcom: >>>> >> ...... >> >> Has the data been snooped for this data to see if all >> is as expected. >> >> If you are seeing a natural MTU running faster than a jumbo MTU >> then something is fragmenting or causing fragmentation of the data. >> Should the MTU=4500 causes overflow errors it might be related to >> fragmentation. >> Both the sender and receiver have to keep all the bits on a reliable >> transfer until the data has been acknowledged. At one time >> fragmentation >> could only be done once to a minimum MTU in the life of a packet. >> >> In addition to snooping packets try "tracepath" to and from all the >> involved boxes to discover what is going on. >> >> > > -- Gerry Creager -- gerry.creager at tamu.edu Texas Mesonet -- AATLT, Texas A&M University Cell: 979.229.5301 Office: 979.458.4020 FAX: 979.862.3983 Office: 1700 Research Parkway Ste 160, TAMU, College Station, TX 77843
- Previous message: [Beowulf] tcp error: Need ideas!
- Next message: [Beowulf] tcp error: Need ideas!
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
More information about the Beowulf mailing list
